Getting T'eeed up for Targe 2018

So in preparation for the Targe show 2018 we have printed some T34s for the Stalingrad Factory game.

3D printed T34,s these have the older chassis with boxes on the back, one with a replacement turret and a couple of replaced wheels.

These take about 24 hours to print.

And also some off board artillery...

203mm Russian Howitzer a resin model from heer46. 

Also as the factory is 5ft long...more boxes and clutter...we're printed to use the end of the pla spool...

This picture shows the difference between the 3d print and the resin model.  Much more detail on the resin. But an ok 3d print....

Factory engine assembly line

For our factory ...I printed an overhead crane with some engines. Then added some crates, boxes pipes, etc.

These are still to be weathered...

I wanted it to look like an engine assembly line.