Tuesday 12 September 2017

Karl Mortar and Morser

3D Prints


New 3d prints are looking good... you might see some of these at Targe in Nov...

28mm 3d print

And we might bring a Mortar....just to look good... It was printed in two parts because its bigger than my 15cm print table LOL. I also liked the shell support vehicle with loading crane.
28mm karl mortar
Printed some oil drums...

28mm karl mortar
3d Ammo crates add to the look.

The Tiger is plastic (with added skirt damage- I got the matches and hot screwdriver out!) but the Famo is 3d-its a massive prime mover.

28mm famo
Check out the engineer on the famo fixing the engine...with a large 3d printed spanner lol...